So, after over a year of wanting to, I finally took the plunge to start a viv. It's not going so well. First, I attempted to apply black silicone to the back and partial sides - I was not at all prepared for how strong the fumes are. wow! And it was very difficult to spread and the finished product is not too good - lots of spots that you can see through it. Oh well.
So, next on to the great stuff. I purchased all these supplies a year ago, but was too intimidated to start. So, tonight I go to use the foam - and nothing will come out - of either one. Am I doing something wrong?! You just screw the nozzle on and pull the trigger, right? There is a small amount of air and foam that comes out from below the nozzle - so I am assuming that it is clogged up, or is there something special I need to do with the nozzle?
So, next on to the great stuff. I purchased all these supplies a year ago, but was too intimidated to start. So, tonight I go to use the foam - and nothing will come out - of either one. Am I doing something wrong?! You just screw the nozzle on and pull the trigger, right? There is a small amount of air and foam that comes out from below the nozzle - so I am assuming that it is clogged up, or is there something special I need to do with the nozzle?